CHHMC - AMPROL TYPE II TRANSFORMER OIL,11104
- MSDS: CHHMC
- Manufacturer: LYONDALL LUBRICANTS
- Product Name: AMPROL TYPE II TRANSFORMER OIL,11104
- National Stock Number: 9160-00-075-9816
Product Identification
Product ID:AMPROL TYPE II TRANSFORMER OIL,11104
MSDS Date:03/24/1997
FSC:9160
NIIN:00-075-9816
MSDS Number: CHHMC
Responsible Party
HOUSTON, TX 77252-2451
US
Emergency Phone: 800-313-7646(800-424-8300 CHEMTREC)
Info Phone: 800-447-4572
Cage: 07G23
Contractor
Telephone: 800-447-4572
Cage: 07G23
Ingredients
SEVERELY HYDROTREATED LIGHT NAPHTHENIC DISTILLATE, (TYPE II
CAS: 64742-53-6
RTECS: PY8036000
Fraction By Weight: 99.5%
OSHA PEL 5 MG/M3 (OIL MIST)
ACGIH TLV: 5 MG/M3 (OIL MIST)
ADDITIVE MIXTURE OXIDATION INHIBITORS (PROPRIETARY)
Fraction By Weight: 0.5%
Hazards
LD50 LC50 Mixture:ORAL LD50 (RAT) IS >5000 MG/KG.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:EYES: NO IRRITATION EXPECTED FROM
SHORT-TERM EXPOSURE. SKIN: MILD IRRITATION FROM SHORT-TERM
EXPOSURE. INHALATION: MISTS OR VAPORS MAY IRRITATE THE MUCOUS
MEMBRANES OF THE NOSE, THROAT, BRONCHI, AND L UNGS. ASPIRATION INTO
LUNGS MAY CAUSE LIPOID PNEUMONIA. INGESTION: NOT LIKELY TO OCCUR.
IT MAY CAUSE A LAXATIVE EFFECT.
Explanation of Carcinogenicity:NONE
Effects of Overexposure:SKIN: MILD IRRITATION FROM SHOT EXPOSURE.
PROLONGED AND/OR REPEATED CONTACT MAY PRODUCE MILD TO MODERATE SKIN
IRRITATION, INFLAMMATION, AND/OR SENSITIZATION. INHALATION:
IRRITATION OF NOSE, THROAT, BR ONCHI, LUNGS. INGESTION: LAXITIVE
EFFECT.
Medical Cond Aggravated by Exposure:PERSONNEL WITH PRE-EXISTING SKIN
DISORDERS, CHRONIC RESPIRATORY DISEASES, OR BLOOD DISORDERS SHOULD
AVOID CONTACT WITH THIS PRODUCT.
First Aid
First Aid:EYES: FLUSH WITH LARGE AMOUNTS OF WATER. IF PAIN OR REDNESS
PERSISTS, GET MEDICAL ATTENTION. SKIN: REMOVE CONTAMINATED
CLOTHING. WASH SKIN WITH LARGE AMOUNTS OF MILD SOAP AND WATER.
INHALATION: NOT EX PECTED TO BE AN PROBLEM UNDER ANTICIPATED
CONDITIONS OF USE. IN CASE OF OVEREXPOSURE, MOVE TO FRESH AIR.
INGESTION: DO NOT INDUCE VOMITING. IF IRRITATION OCCURS, GET
MEDICAL ATTENTION.
Fire Fighting
Flash Point Method:PMCC
Flash Point:300F,149C
Lower Limits:1.0 %
Upper Limits:7.0%
Extinguishing Media:SMALL FIRE: DRY CEMICALS,CARBON DIOXIDE, FOAM,
WATER FOG, INERT GAS(HALON OR NITROGEN).LARGE FIRES:WATER
FOG,SPRAY,FOAM.
Fire Fighting Procedures:NEVER USE WATER JET,MAY SPREAD FIRE.
FOAM/WATER ARE EFFECTIVE,MAY CAUSE FOAMING.WEAR PROTECTIVE
CLOTHING/EQUIPMENT.COOL CONTAINERS EXPOSED TO FIRE WITH WATER.
Unusual Fire/Explosion Hazard:CONTAINERS EXPOSED TO FIRE MAY BURST OR
LEAK FLAMMABLE VAPORS THAT CAN BURN IN OPEN OR BE EXPLOSIVE IN
CONFINED SPACES.MISTS MAY BE FLAMMABLE BELOW FLASH POINT.
Accidental Release
Spill Release Procedures:CONTAIN SPILL AND PREVENT IT FROM ENTERING ALL
WATER BODIES.MAXIMIZE RECOVERY FOR REUSE OR RECYCLING.TAKE UP
EXCESS WITH SAND OR OTHER INERT NON-COMBUSTIBLE ABSORBENT AND PLACE
IN APPROPTIATE CONTAINE RS FOR LATER DISPOSAL.COMPLY WITH ALL
REGULATIONS.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:TO AVOID PRODUCT DEGRADATION, WATER
CONTAMINATION SHOULD BE AVOIDED AND MINIMUM HANDLING TEMPERATURES
SHOULD BE MAINTAINED.MINIMIZE EXPOSURE TO >200F.
Other Precautions:KEEP CONTAINER CLOSED AND IN A DRY, COOL,
WELL-VENTILATED PLACE. STORE AWAY FROM EXTREME HEAT, RADIATION
SOURCES, AND STRONG OXIDIZING AGENTS. DO NOT PUNCTURE, INCINERATE,
OR STORE CONTAINERS AT TEMPE RATURES ABOVE 120F OR IN DRECT
SUNLIGHT.
Exposure Controls
Respiratory Protection:NONE NORMALLY REQUIRED WITH ADEQUATE
VENTILATION. IF TLV/PEL OF 5 MG/M3 IS EXCEEDED WEAR PROPER
NIOSH/MSHA APPROVED VAPOR CONTOL RESPIRATORY EQUIPMENT.
Ventilation:PROVIDE EXHAUST VENTILATION/ENGINEERING CONTROLS TO KEEP
AIRBORNE CONCENTRATIONS OF MISTS/VAPORS BELOW APPROVED LIMITS.
Protective Gloves:DISPOSABLE,VINYL,NITRILE,NEOPRENE GLOVES
Eye Protection:SAFETY GLASSES,OR GOGGLES,OR FACE SHIELD
Other Protective Equipment:AVOID SKIN CONTACT OR WEAR IMPERVIOUS
PROTECTIVE CLOTHING. PROVIDE EYE WASH STATION AND SAFETY SHOWER
NEAR WORK-STATION.
Work Hygienic Practices:WASH HANDS AFTER HANDLING AND BEFORE EATING,
DRINKING, OR SMOKING. LAUNDER CONTAMINATED CLOTHING BEFORE REUSE.
Supplemental Safety and Health
POTENTIAL TREATMENT AND DISPOSAL METHODS FOR WASTE MATERIAL INCLUDE
INCINERATION AND LAND FARMING, IF PERMITTED.
Chemical Properties
HCC:N1
Boiling Pt:B.P. Text:480F,249C
Vapor Pres:0.1 MM HG
Vapor Density:>10 AIR=1
Spec Gravity:0.88-0.91
pH:UNKNON
Solubility in Water:NEGLIGIBLE
Appearance and Odor:TRANSPARENT,LILY WHITE TO SLIGHTLY YELLOW LIQUID.
HYDROCARBON LUBE OIL ODOR.
Percent Volatiles by Volume:NEG
Stability
Stability Indicator/Materials to Avoid:YES
STRONG ACIDS, ALKALIES, OXIDIZERS SUCH AS OXYGEN AND LIQUID CHLORINE.
Stability Condition to Avoid:EXTREME HEAT, OPEN FLAME.
Hazardous Decomposition Products:SMOKE, CARBON MONOXIDE, CARBON
DIOXIDE, PHENOL, AMMONIA, OXIDES AND OTHER COMPOUNDS OF
NITROGEN.FREE AROMATIC AMINES.
Disposal
Waste Disposal Methods:USE APPROVED TREATMENT TRANSPORTERS AND DISPOSAL
SITES IN COMPLIANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS.
SPILL MATERIAL IS BIODEGRADABLE IF GRADUALLY EXPOSED TO
MICROORGANISMS. PREFERABLY IN AN AEROBIC ENVIRONMENT.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.